These are the things you will need :-
- 1 piece of 10 feet by 1 inch by 4 inch wood plank.
- 1 10-foot long PVC pipe, 1.5 inch in diameter.
- 26 pieces of ¾ inch self tapping screws.
- 4 pieces of 2-inch self tapping screws.
- Drill.
- Screw driving bit.
- Hole drilling bit.
- Tape measure.
- Pencil.
- Saw.
- Sandpaper.
Ok I think you all have got the things to start the work
Step 1 :-
- Measure 70 inches on the wood plank.
- Mark with a pencil.
- Saw the wood at the 70-inch mark and set the
- Excess wood aside.
Step 2 :-
- Mark one side of the wood plank every 10 inches starting from one end.
- Turn the plank on the other side and start marking from one end, first by 5 inches and then every 10 inches.
- This will give 5 inches of space in between each fishing rod, on alternating sides, when the project is done.
Step 3 :-
- Get the excess wood plank and cut 2 pieces 8-inches each, which will be used for the fishing rod rack's feet.
- Screw the wider side of the feet to one end of the 70-inch wood plank using the 2-inch self tapping screws.
- Lower the feet about half an inch to raise the rack off the ground and add to its stability.
- Repeat with the other piece of 8-inch wood.
Step 4 :-
- Grab your PVC pipe.
- Measure and mark every 9 inches and saw off each section.
- You can sandpaper the ends of each tube to smooth out the sharp edges.
Step 5 :-
- Measure an inch from the bottom end of the PVC pipes and mark with a pencil.
- Then measure about 2 inches from the first mark.
- Drill a pilot hole in your PVC pipe sections on the places where you marked.
- This hole is your screw driver access.
Step 6 :-
- Attach the PVC pipes right on the markings on your wooden rack using a drill with the screw driving bit and the ¾ inch self tapping screws.
Ok now the Fishing Rod Rack is done . Have fun
Please note that this post is just edited by me to make easy for readers . And the original post can be found on ehow.com thanks . Remember to leave your comments. Have a nice day .
